FAQs

FAQS

Menene babban iri SPS squeegee?

SPS squeegee ta kasu uku da manyan Categories: 1. Traditional M-type squeegee (ba tare da goyon bayan farantin). 2, FGB fiberglass scraping. 3, AS unilateral carbon fiber scraping danko.

Akwai da dama model na roba ɓangare na SPS squeegee?

Akwai halin yanzu biyu model, daya ne M-type roba amfani a cikin M-type da kuma FGB fiberglass bangarori, da kuma sauran ne PLUS roba amfani a cikin AS-carbon fiber (conductive, mafi sauran ƙarfi-resistant, kuma mafi wear- resistant).

Mene ne size bayani dalla-dalla na irin M scraping manne?

M model da 9 * 50, 9 * 30, 7 * 40, 5 * 25, 5 * 20 tip kauri bisa ga kauri, kuma za a iya musamman bisa ga abokin ciniki bukatun.

Mene ne girma daga FGB fiberglass scraper?

A gargajiya allo bugu masana'antu FGB fiberglass scraping bayani dalla-dalla na 9 * 50, da tsawon yankan bisa ga abokin ciniki bukatun. Za a iya musamman bisa ga abokin ciniki bukatun.

Mene ne girma daga AS carbon fiber squeegee?

A gargajiya allo bugu masana'antu AS carbon fiber scraping bayani dalla-dalla 7 * 50, tsawon bisa ga abokin ciniki bukatun. Za a iya musamman bisa ga abokin ciniki bukatun.

Mene ne tsarin fayil da gyare-gyare lokaci da ake bukata domin al'ada da sabis?

3D: STP, XT. CAD: 2000 version, al'ada lokaci: a cikin 5 aiki kwanaki

Is it possible to grind the SPS squeegee?

The iri uku scraper za a iya kasa. M model da FGB model guda iyakar nika adadin 0.5mm (200 raga nika dabaran). AS carbon fiber scraping guda iyakar nika adadin 0.1mm (200 raga nika dabaran, carbon fiber kwamitin za a iya kasa). A squeegee cewa da ya shigo an yi amfani up ƙunshi mai yawa sauran ƙarfi a ciki. Taurin da wuka baki ne ma low a ƙasa nan da nan. Yana daukan kawai 24 hours kafin nika.

Yadda za a kafa FGB fiberglass scraper da kuma AS carbon fiber scraper cikin al'ada maras motsi?

Duka FGB fiberglass scraper da AS carbon fiber scraper ne 1.2mm lokacin farin ciki. Su za a iya shigar da wani 8mm m kushin, wanda za mu iya samar da.

Maintenance na SPS squeegee?

The squeegee is printed for a long time, and the solvent easily erodes the squeegee blade. The hardness and wear resistance of the squeegee are reduced. Therefore, after the squeegee has been printed for a long time, it needs to be cleaned, and after being left for 12-24 hours, it is used or ground again. If stored in a low-temperature environment, soak it in 30°C warm water for 10 minutes before use. Dry it with a cloth and use it. When the squeegee is left for a long time, it is forbidden to touch the other side of the squeegee to prevent the squeegee from deforming.