FAQs

FAQS

aina kuu ya SPS squeegee nini?

SPS squeegee imeainishwa katika makundi matatu makubwa: 1. Traditional M-aina squeegee (bila msaada sahani). 2, FGB fiberglass kugema. 3, AS upande mmoja carbon fiber kugema gum.

Kuna mifano kadhaa ya sehemu za mpira wa SPS squeegee?

Kwa sasa kuna mifano miwili, mmoja ni M-aina ya mpira kutumika katika M-aina na FGB fiberglass paneli, na nyingine ni PLUS mpira kutumika katika AS kaboni fiber (conductive, zaidi kutengenezea sugu, na zaidi wear- sugu).

ni kawaida specifikationer ya M aina kugema gundi nini?

M mifano ya kuwa na 9 * 50, 9 * 30, 7 * 40, 5 * 25, 5 * 20 ncha unene kulingana na unene, na inaweza kuwa umeboreshwa kulingana na mahitaji ya wateja.

ni vipimo ya FGB fiberglass kombe gani?

jadi sekta screen uchapishaji FGB fiberglass kugema specifikationer ya 9 * 50, urefu wa kukata kulingana na mahitaji ya wateja. Inaweza kuwa umeboreshwa kulingana na mahitaji ya wateja.

ni vipimo ya AS carbon fiber squeegee nini?

jadi screen sekta ya uchapishaji AS carbon fiber kusugua specifikationer 7 * 50, urefu kulingana na mahitaji ya wateja. Inaweza kuwa umeboreshwa kulingana na mahitaji ya wateja.

ni faili na customization wakati inahitajika kwa ajili ya huduma za desturi gani?

3D STP, XT, CAD: 2000 version, muda maalum: kati ya siku 5 za kazi

Is it possible to grind the SPS squeegee?

aina tatu za kombe inaweza ardhi. M mtindo na FGB mfano moja ya kiwango cha juu ya kusaga kiasi 0.5mm (200 mesh kusaga gurudumu). AS carbon fiber kugema moja ya kiwango cha juu ya kusaga kiasi 0.1mm (200 mesh kusaga gurudumu, carbon fiber bodi pia inaweza ardhi). squeegee kwamba ina tu kutumika hadi ina idadi kubwa ya ndani ya kutengenezea. ugumu wa kisu makali ni ya chini sana kwa kuwa ardhi mara moja. Inachukua masaa 24 pekee kabla ya kusaga.

Jinsi ya kufunga FGB fiberglass kombe na AS carbon fiber kombe katika mechi ya kawaida?

Wote FGB fiberglass kombe na AS carbon fiber kombe ni 1.2mm nene. Wanaweza kuwa imewekwa kwa 8mm pedi nene, tunayoweza kutoa.

Matengenezo ya SPS Squeegee?

The squeegee is printed for a long time, and the solvent easily erodes the squeegee blade. The hardness and wear resistance of the squeegee are reduced. Therefore, after the squeegee has been printed for a long time, it needs to be cleaned, and after being left for 12-24 hours, it is used or ground again. If stored in a low-temperature environment, soak it in 30°C warm water for 10 minutes before use. Dry it with a cloth and use it. When the squeegee is left for a long time, it is forbidden to touch the other side of the squeegee to prevent the squeegee from deforming.